Electrical Connections; Connection Cables - Tecomec GEOline Manual De Uso Y Mantenimento

4 6
4 INSTALLATION
ENG

Electrical connections

The supply voltage is direct current 12V ±10% (12 VDC).
The displais has a 10A protection fuse).
Geoline control units can be supplied with a kit for electrical connection to the control panel, upon request.

Connection cables:

a - probe connection cable (code C00900016).
Used to connect the probe to the display.
Length 4 m (included in the level indicator kit)
b - display connection cable
Used to connect the display to the probe
Length 1m (cable included with the control panel).
c - Main power cable (with two free wires at the end)
Used to connect the display to the 12V battery on the tractor.
This cable is already connected to the display panels.
An electrical plug for connection with the tractor can also be supplied upon request.
d - extension cable (code C 00900018).
Used to connect the probe to the display.
Length 4 m (not included in the level indicator kit).
a1
d
Fuse
b
c
a
a2
Plug
RED BLACK
The electrical connections are indicated below:
- connect the plug a1 on cable a to the probe (lock into position using the fixing screws).
- Connect the plug a2 on cable a to cable b.
- connect cable c to the tractor battery. If a cable with an electrical plug is used, connect it to the tractor's
12 VDC outlet.
- If required, use the extension d between cables a and b.
25
U s e & M a i n t e n a n c e M a n u a l