Service & Maintenance; Optional Accessories - Triton SJA200 Instrucciones De Funcionamiento Y Seguridad

SERVICE & MAINTENANCE
• Any damage to Superjaws should be repaired
and carefully inspected before use, by
qualified repair personnel.
• Servicing should only be carried out using
original Triton replacement parts.
• Triton Tools will not be responsible for any
damage or injury caused by unauthorised
repair or mishandling of the machine.
REMOVING THE URETHANE JAW FACINGS
The jaw facings can be removed to achieve a
greater clamping range, or for replacement if
worn or damaged, or when fitting the optional
jaws.
1. The fixed jaw facing (1)
is removed by prying it
off the fixed jaw (14)
using a screwdriver
or similar.

OPTIONAL ACCESSORIES

ENGINEERS JAWS (SJA470)
The bolt-on jaws are
manufactured from
an extremely strong
ductile cast iron, and
are specially shaped
to increase grip when
clamping pipe or round
sections up to 50mm in diameter. They also have
an integral anvil for hammering or bending of
heavy metal sections.
LOG AND POLE GRIPPING JAWS (SJA460)
Suitable for gripping logs or poles, these
jaws also bolt onto the
GB
standard steel jaws and
are formed from steel
plate, zinc plated for
corrosion resistance.
Logs or poles up to
175mm in diameter are
gripped firmly for chain sawing, drilling, rebating
etc.
Maintenance / Optional Accessories
8
2. To remove the moving
jaw facing, push
the backing face
to the right (when
viewed from the
front of Superjaws)
to disengage the
connection pins. The
backing face can then
be removed, allowing
the front to be pulled
off the moving jaw.
The pawl carrier pivot pin
may occasionally require
a small amount of spray
lubricant, as shown, if it
doesn't pivot smoothly.
EXTENSION TRAY (SJA420)
The Extension Tray fits
through the mounting
holes (12) in either side of
the main body. It provides
outboard support for the
workpiece, keeping it
level while clamping into
position. A tough high density polyethylene tray
locates onto the support tubes as a convenient
place to hold tools and other bits and pieces.
For additional support and capacity a second
Extension Tray can be fitted onto the opposite
side of Superjaws.