Poolmaid X Serie Manual De Instrucciones página 6

The Poolmaid Weir Valve
To ensure your Poolmaid's optimum
performance, we have included a
Poolmaid Weir Valve. This valve will
immediately give you the state of
your filter system. Should your filter
require backwashing, this will be
clearly visible by observing the posi-
tion of the flow indicator.
Installing the Valve
The valve should be fitted to the
inlet/suction in your pool weir/skim-
mer box.
i. Turn off the pump
ii. Disconnect the pool hose from
the weir box
iii. Ensure the baskets contain no
debris
iv. Backwash the filter, with the
hose removed, before installing
the weir valve
v. Install the valve in the weir
vi. Turn on the filtration system
vii. Attach the Poolmaid to the cor-
rect length of hoses (refer to
page ) taking care to purge the
air out of the hoses by holding
the end of the first hose over the
water return outlet/aim flow
viii. Connect hose to weir valve
ix. Close the flow equalizer.
x. If the suction is too high, open
the flow equalizer until the flap
operates between "low" and
"high"
Tip:
Always follow instruction i) & ii) when
backwashing in the future

Decrease
Flow
Flow
Equalizer
Increase
Flow
Flow
Indicator
(Fig. )