Poolmaid X Serie Manual De Instrucciones página 7

Problem
1. Poolmaid does not move
with the pump running
. Obstacle in hose
. Poolmaid is stuck in a spe-
cific place
4. Cleaner climbs out of the
pool
5. Air flowing out of the
return nozzle
Trouble Shooting
Probable Cause
i. Hose is disconnected
ii. Leaf basket is full
iii. Filter is not backwashed
iv. Obstacle in the flapper
chamber
v. Hose has a hole
vi. Disc does not rotate freely
i.
Stuck in a corner or on a
light fitting
i. Hose has a leak
Suggested Solution
SWITCH OFF PUMP
i.
Reconnect hose
ii.
Empty leaf basket; and
iii.
Backwash filter
iv.
Pull any visible obstacles
out - If it does not solve
the problem, remove flap-
per cover, remove flapper,
inspect chamber and
remove any obstacles,
rinse. Refit flapper, then
flapper, cover by placing
the left location pins into
the left holes push the
right side of the flapper
cover, clicking the pins
into their corresponding
holes. Inspect the outside
of the body to see if all
four pins have located
v.
Replace section of dam-
aged hose
vi.
Ensure disc is installed as
outlined on page 
i.
Remove obstacle
i.
Remove from the obstacle
ii.
Adjust bump strip lower
or higher
iii.
Decrease suction slowly
by slightly opening the
flow equalizer
iv.
Adjust the return nozzle
to drive the poolmaid
cleaner away from the
obstacle, by turning the
return nozzle toward the
hose.
i. Open flow equalizer
slowly or adjust float to
a lower position.
i. Check hose for leaks
ii. Ensure hose sections
are tightly connected.
iii. Check o-ring at pump,
replace if worn.