Hella 2PT 008362-801 Instrucciones De Montaje página 11

Page 3:
Electrical connection
15
85
11
Page 6:
Accessories
(not included with kit)
Push-in adapter mounting set
Disconnect earth lead (-) from
battery as precaution.
Install relay with connection ter-
minals downwards so that they are
protected against splashing water:
If required and permitted by law,
mount switch on dashboard.
Route and connect leads according
ø 12 mm
to circuit diagram.
According to circuit diagram
daytime driving lamps are switched
on automatically together with the
ignition.
According to circuit diagram
the daytime driving lamps can be
switched on and off with a separate
switch.
Reconnect earth lead (-) to battery.
Check lights. Securely fasten con-
nection leads.
Caution!
Daytime driving lamps
•Are not a substitute for dipped
beams at dusk or in the dark.
•Illuminate only when the vehicle
lighting is switched off and the
ignition is switched on.
•Switch off automatically when
I , the
the vehicle lighting is switched on.
•Are approved according to ECE
R87
II
,
•May be attached according to EC
Guidelines EC R97/28 and ECE
R48.
We recommend keeping the
mounting instructions with the
vehicle papers.
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80 % of the light. You
drive safely when you can see and
be seen well. Do you have spare
bulbs and fuses in the car? If you
have any questions or problems
with installation: Contact the Hella
Service Department.