GYS SPOT LIFT PRO Manual De Instrucciones página 11

SAFTEY AREA
For an optimal safety, it is recommended to make sure that any other objects or walls are away. Any handling work
must be done with care from the operator. Nobody must be stand in the safety area. In order to secure the operator,
the command remote box must be situated at a distance where the operator can get away easily in case of emer-
gency.
INDIVIDUAL PROTECTION
The operator must be equipped following prevention standards and must take the necessary actions to maintain
safety. During manoeuvres, the operator must protect his safety and people safety. The operator must take into
consideration all the recommendations quoted in this manual.
INSTALLATION
Once the product out of is packaging , assembled and on the floor, make a try to check the good functionning. Com-
mand remote box is fixed on the guidance lever.
Start and verification (attempt)
- Screw the compressed air connection tip on the command remote box and connect it to the
compressed air supply.
- Check that the pressure is correct (between 6 and 9 bar).
- Check that there is no air leakage.
LIFTING CHECK:
After the verifications above, push the joystick up continuously in order to raise the SPOT LIFT
PRO. Once the maximum height is reached, release the joystick in order to put it back to its
initial position.
DESCENT CHECK:
Before any operation, make sure that nothing is under the SPOT LIFT PRO.
To lower the product, push the joystick down continuously. The SPOT LIFT PRO will descend to
its lowest point.
If these 2 steps have been successful, the product is ready to use.
INSTRUCTIONS
1/ LIFTING OPERATION
WARNING: Before lifting a vehicle, make sure that the hand brake is released, that the vehicle is on
neutral and that tyres pressure is enough to maintain the vehicle in balance.
Position the SPOT LIFT PRO under the vehicle, centre it, for vehicle width.
Extend the arms until that the rubber pads are in position for the jack. Pads
are height adjustable. Fix the height with the small bar in order to be as close
as possible to the lowest part of the vehicle. Once the tool is positioned operate
the lift:
- Check that nothing very bulky is inside the safety area.
- Push continuously the joystick up
- Once you have reached the height you wisk, stop pushing the joystick and the SPOT LIFT PRO will stop to go up.
- Put the 2 safety links in place to support the vehicle immediately after lifting. (these must not be put in place from
under the vehicle)
SPOT LIFT PRO
EN
11