Using For The First Time; Setting Up And Connecting The Coffee Machine; Filling With Water; Switching The Coffee Machine On - Electrolux AEG CP 2 Serie Instrucciones De Uso

822_949_318 CP2..._defnep.book Seite 33 Freitag, 2. November 2007 6:30 18
4

Using for the First Time

4.1 Setting Up and Connecting the
Coffee Machine
Place machine on a suitable horizontal,
stable, unheated, dry and water-resist-
ant surface. Ensure good air circula-
tion.
Important! If the coffee machine is
brought into a warm room from a cold
environment, wait about two hours
before switching on!
We advise you to place the coffee
machine on a suitable mat to prevent
damage being caused by spray and
splashes.
0 Hold the bean container with the
marking on the "Unlock container"
position, and set it in place (Fig. 4).
The bottom opening of the bean con-
tainer must be closed (Fig. 4,a). If it is
not closed (Fig. 4,b), insert the tip of a
ballpoint pen in the small oval hole
(arrow) of the black ring with the
marking "TOP" and turn opening clock-
wise as far as the stop.
0 Now turn the bean container anti-
clockwise to the position "Coffee
beans" (Fig. 10) or further on to
the position "Powder"
0 Push the drip tray in, until it engages
on the right under the water tank
(Fig. 5).
0 Plug the coffee machine into an
earthed mains socket. Do not use a
socket that is not earthed!
0 If you do not need the full length of
the mains lead, open the cable com-
partment on the back of the coffee
machine, and tidy away the unused
lead (Fig. 6).
4.2

Filling with Water

Each time before switching on the cof-
fee machine, check that there is water
in the water tank and refill if necessary.
The coffee machine requires water for
the automatic rinsing processes each
time the machine is switched on or off.
0 Remove the water tank from the cof-
fee machine (Fig. 7).
0 Fill the water tank with fresh cold
water (Fig. 8).
Pour only fresh cold water in the water
3
tank. Never put in other liquids, e.g.
mineral water or milk.
0 Replace the water tank (Fig. 7). Press
the tank firmly in, to ensure that the
water-tank valve opens.
If water must be refilled during the use
3
of the coffee machine, the "Fill water
tank" indicator (Fig. 3, k)
Coffee resp. hot water/steam prepara-
tion is interrupted. Fill the water tank!.
To always be sure of a rich coffee, full
3
of aroma, you should:
• change the water in the water tank
daily
• wash the water tank at least once per
week in normal washing-up water (not
in the dishwasher). Then flush with
fresh water.
4.3 Switching the Coffee Machine
On
0 Switch the coffee machine on by
means of the "On/Off" key (Fig. 3, h)
(Fig. 14).
(Fig. 9). The red indicator light
comes on. While the water is being
heated (approx. 60 seconds) the "Cof-
fee machine heating" indicator (Fig. 3,
i) flashes.
0 Once the operating temperature has
been reached, the coffee machine car-
ries out an automatic flushing cycle.
The water flows out into the drip tray.
The "Coffee machine heating" indica-
tor (Fig. 3, i)
The coffee machine is now ready to
use.
Immediately after being switched on
3
the coffee machine runs through a set-
up cycle. The noises this creates are
completely normal.
g
flashes.
remains constantly on.
33