Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
Very solid grease pump, very comfortable foot action. For all types of lubricants, with spring actionned grease compacting piston, to be used with heavy greases. Maximum pressure
7350 psi (500 bar). Delivery per cycle: 0.07 ounces (2 g).
Very solid and easily transported 11 lb (5 kg), leak proof container. Pump with air purger, high pressure 2 m hose and nozzle with valve (14516).
INSTALLATION
Fig. 1
LOADING
Fig. 2
TECHNICAL SERVICE
REPLACEMENT OF THE PISTON JOINT
!
WARNING! Before starting any work relieve the spring tension and reduce the pressure!
1.
With the spring unloaded, turn the grips until the lateral opening is obtained.
2.
Lift the top part of the pump and replace the joint in a way that the lips of the said joint remain towards the bottom (fig. 1).
3.
Assemble in the opposite way.
REPLACEMENT OF THE TORSION SPRING AND PINION ASSEMBLY
1.
Remove the top part of the pump, and place it upside down.Remove the inside screws and remove the base.
2.
In this position, lift the pedal and remove the pin. Remove the torsion spring and/or pignon.
3.
To replace the torsion spring, place the new one in its position and the pignon as per indications in fig. 2. Introduce the assembly axe-pedal.
4.
Lift the inside end of the spring with the help of a screwdriver until pin bearing is surpassed (fig. 3). Introduce this piece completely.
5.
To replace the axe-pinion assembly, dismount following instructions stated in paragraph 1 and 2.
6.
Remove the cap nut and separate the axe from the pedal. Replace the axe in a way that the pin bearing is in line with the pedal and the smaller diameter side of the said conical
hole situated on the opposite side of the pedal (fig 4).
7.
Mount the set as per paragraph. 3.
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
2
1.
Screw the high pressure hose (1) to the outlet valve placed on the bottom part of
the pump (2).
2.
To distribute grease, charge the container following instructions stated in the next
paragraph.
3.
Then adjust the hydraulic nozzle at the greasing point and proceed with the supply
by means of pedal strokes.
Important: When accomplishing this movement let the pedal return to its original
position in order to allow the adequate amount of grease to be loaded in the piston.
A. Firmly hold the pump on the floor by stepping on the base and pulling up the rod (1)
until the pin (2) surpasses the top opening (detail).
B. In this position, turn the rod (1) until the pin(2) prevents it from returning to its
original position.
C. Turn the grips (3) until the rod and topo may be removed. Remove the top part of
the pump (4) and proceed to fill the container.
D. After the filling, turn the grips to original position and turn the rod (1) until the pin
crosses the top rut and releases the rod. Pressure is now on the spring an follower.
Publicidad
