AL-KO TOP 1202 H Manual Del Usuario página 12

GB
−
Hexagon-head bolt
−
Hexagon-head lock nut
5. Tighten the hexagon-head nut – then un-
screw by ¼ revolution (approx. 0.5 mm
gap).
Information:
When released, the hand wheel must
lock into position in the retention plate.
Drum and gear rim assembling
Figs. 12 and 13
1. Applying silicone on the lower drum calculat-
ingly.
Put on the upper drum half on the lower drum
half so that the two square holes are located on
each other.
Screwing drum.
−
Hexagon-head bolt M6 x 14
−
Washers
−
Hexagon-head lock nut M 6
Mixer metals and gear rim protection
Assembling
Fig. 14 a, b, c
1. Stick two round head screws with two seal-
ing of the outside by the square holes.
2. Putting reinforcement's metals and mixer
metal on to the screws and with one washer
each and hexagon screw in, tight screw.
3. Putting the fastening metal (figure 14b) on
the side of the hand wheel on the cone.
4. Assembling a half of the gear rim protection
on the two sides and fix screws tangible.
5. Assembling second half of the gear rim
protection and fix screws tangible.
6. Adjust gear rim protection and fix all screws.
Operation
Danger!
!
The concrete mixer must not be oper-
ated if any parts (e.g. guards) are miss-
ing or defective or if the connection cable
is damaged.
Operating the concrete mixer
1. Place the concrete mixer horizontally on
level, solid ground. Do not place the con-
crete mixer on the connection cable!
GB 3
M12 x 45 (1x)
M12 (1x)
Lay the connection cable in such a way that it
cannot be kinked, crushed or damaged in any
other way.
Plug the connection cable into the machine.
Plug the connection cable into the mains socket.
Fig. 15
1. Switching on: Switch to "1".
2. Switching off: Switch to "0".
(12x)
(12x)
(12x)
Drum positions
Fig. 16
1. Operating position (can swivel to the right or
Fig. 17
Transportation and storage
1. If there are any prolonged breaks in work,
Transportation
Übersetzung der original Gebrauchsanweisung
Information:
The drum must be able to swivel to the
right and left. Ensure that there is space
under the drum for emptying the con-
tents into a wheelbarrow.
Information:
Verify the rotating direction of the drum
when using a concrete mixer with three
phase current motor (TOP 1403 HR).
When looking into the mouth of the
drum, the drum has to rotate counter
clockwise. If not, the phases of the feed
cable had been changed and have to be
reconnected.
Danger!
!
The reconnection of the phases may
only be executed by a qualified electri-
cian.
left).
Information:
When released, the hand wheel must
lock into position in the retention plate.
Warning!
The drum must be rotating when it is
being filled or emptied. Do not overfill
the drum!
disconnect the power and safeguard the
concrete mixer to prevent it from being
switched on by unauthorised persons.