Worx WG300 Manual De Instrucciones página 13

When the log is supported on both ends, as
illustrated in Figure V, cut 1/3 the diameter
from the top (overbuck). Then make the
finished cut by underbucking the lower 2/3 to
1
meet the first cut.
1/3
1
1/3
1
When bucking on a slope always stand on
1/3
the uphill side of the log, as illustrated in
Figure VI. When "cutting through" , to maintain
complete control release the cutting pressure
near the end of the cut without relaxing your
grip on the chain saw handles. Don't let the
chain contact the ground. After completing the
cut, wait for the saw chain to stop before you
move the chain saw. Always stop the motor
before moving from tree to tree.
Electric Chain Saw
2/3
SYMBOLS
2
2/3
2
2/3
2
2/3
To reduce the risk of injury, user
must read instruction manual.
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
Do not expose to rain
Remove plug from the mains
immediately if the cable is damaged
or cut.
Contact of the guide bar tip with any
object should be avoided.
Tip contact can cause the guide
bar to move suddenly upward and
backward, which can cause serious
injury.
Always use two hands when
operating the chain saw.
13
EN