Operating The Unit - Amann Girrbach smartmix X2 Instrucciones De Operación

InstallatIon
After unpacking the unit, please check it immedia-
tely for possible damage incurred during transport.
Should the unit have been damaged during
transport, please c omplain to your supplier im-
mediately. Although this unit is supplied ready for
use, always check the voltage setting (115/230 V)
immediately above the power socket. If you are
not certain which voltage is used in your c ountry,
please ask your local supplier of electrical
a ppliances.
InstallIng on a Bench
The stand is available as an accessory and consists
of a firm, heavy base with a back. The Smartmix X2
is attached with its backside to the four screws
at the backside plate of the pedestal. Turn in the
securing screw to prevent unintended separation
of the device from the pedestal. The unit is then
ready for use.
fIttIng to a Wall
A wall drilling template is supplied with the unit
for d rilling holes in the wall quickly and exactly.
Ensure that the holes are aligned exactly and
horizontally (check with a spirit level if necessary).
Once the holes have been d rilled, press the raw-
plugs into them. Screw in the screws until appro-
ximately 5 - 6 mm protrude and hang the unit
on them.
o P e r at I n g I n s t r u c t I o n s
caution: special rawplugs must be used for
sandwich-type plaster board walls!
1. Stick template onto required wall mounting
position.
2. Mark the center of the 4 crossed lines using a
tip end instrument.
3. Remove template and drill the holes. Now you
can press the enclosed dowels into the holes.
Screw the enclosed bolts into the dowels and
leave a 0.20 - 0.24 inch space before they
align with the dowels.
4. The bigger holes on the back (marked black
on this template) will help you finding the
screw-positions when hanging Smartmix X2
onto the wall. Check carefully if the device has
engaged correctly on your wall before removing
the weight from your arms when holding the
device.

oPeratIng the unIt

To start the Smartmix X2, first turn on the On/
Off switch at the underside of the device. At the
front, the device is equipped with a two-line LC
display (a) and the multifunctional turning and
pushing knob (B). Using these controls, all
functions of the Smartmix X2 can be reached.
The device is ready for action immediately after
power-up. When the Smartmix X2 is turned on for
the first time, the language selection menu will
appear. Select the desired language and confirm
by pressing the button. After each subseqent
start of the system, the stirring program most
recently used will be indicated on the display.
gB
11