Gima LUX 100 Manual De Uso Y Mantenimiento página 6

FEATURES
The ENT forehead mirrors are local lighting devices with luminous forehead mirror particularly
useful to examine the oral cavity, the nose and the ear.
These products are equipped with mirrors made of special enameled glass and are assembled
on a practical helmet, adjustable and adaptable to the operator's head.
The following models are available:
31107 LUX-100 battery head mirror (LED)-(2 x 3V CR-123A) - Ø 100 mm - 3V
31108 LUX-55 battery head mirror (2 x 3V CR-123A) - Ø 55 mm - 6V
31109 LUX-100 battery head mirror (2 x 3V CR-123A) - Ø 100 mm - 6V
31110 LUX-55 AC/DC transformer head mirror - Ø 55 mm - 6V
31111 LUX-100 AC/DC transformer head mirror - Ø 100 mm - 6V
The packaging includes a mirror with head band, a 6V bulb, 3 V (LED), and a power cable
and plug-in transformer or a battery compartment (depending on the model).
PRESCRIPTIONS
The mirrors are very delicate and shall be handled carefully.
The product shall be used by qualified personnel only.
Do not use the equipment in case it is damaged. Apply to your retailer.
Avoid precarious repairs. Repairs shall be carried out with original spare parts only,
which shall be installed according to the intended use.
Broken bulbs or mirrors can cause injuries or cut. Carefully handle and immediately
replace.
Since the product is made of corrosion-proof materials suitable for the enviromental conditions
foreseen for its normal use, does not require special care, however it is necessary to store
it in a closed place making sure that is protected from dust and dirt to assure its hygenic
conditions. Moreover, it is recommended to store the product in a place which can be reached
easily by the personnel in case of necessity.
UNPACKING
Always remember that packing elements (paper, cellophane, stitches, adhesive
tape, etc.) can cut and/or hurt if they are not carefully handled.
They shall be removed with adequate means and shall not be left at the mercy of
irresponsible persons; the same is valid for tools used to remove packages (scissors,
knives, etc.).
After opening the packages, first of all it is necessary to check all pieces and parts composing
the product. Check that they are all present and in perfect conditions.
INSTALLATION
- Before using the product, it is possible to adjust the helmet to the head size. To do this, make
use of the apposite adjusting screw located on the back allowing tightening or loosening the
headband.
- The devices come with mirrors in two diameters, 100 mm and 55 mm. The device can be
powered by either a direct mains adaptor or a battery box.
- The product is available in the version with external adaptor or the version with battery compartment
ENGLISH 6