Programming Channel Control Lock; To De-Activate Channel Control Lock - COX M7820 Guía Del Usario

3.
4.
5.
6.
PROGRAMMING CHANNEL
CONTROL LOCK
By default, the remote control' s channel-control capabilities
are locked to the cable converter. The affected keys are 0 ~9,
CH+, CH–, ENTER, and LAST. This will guarantee that you
do not inadvertently change a channel on your TV or VCR.
However, you can de-activate this feature to allow full access
to these keys in the TV and VCR modes.

To De-Activate Channel Control Lock:

1.
2.
3.
4.
M7820BP1.indd 14
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
Enter 9 - 8 - 2. The CABLE key will blink
four times.
Perform the instructions in Programming
Device Control on page 9 to program device
control for the desired cable converter and
interactive service. Upon completion, perform
the remaining steps (5 and 6 on this page) to
again lock the ID lock.
On the remote control, press CABLE once.
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
Enter 9 - 8 - 2. The CABLE key will blink
twice.
On the remote control, press CABLE once.
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
Enter 9 - 7 - 3. The CABLE key will blink twice.
Press CH– once. The CABLE key will blink
four times.
Now, the remote control will provide TV and
VCR channel-control capabilities while in TV
or VCR mode.
NOTE: This feature does not affect the AUX
mode.
14
3/13/2007 3:54:00 PM