Re-Assigning Device Keys - COX M7820 Guía Del Usario

RE-ASSIGNING DEVICE KEYS

The Cox Universal Remote Control can be set up to
control a VCR or second TV, or any combination of up to
four home entertainment devices. For example, to have
the unit-control a TV, a Cable Converter, a DVD player
and a VCR, you will need to re-assign the unused AUX
key to operate the VCR as follows:
1.
2.
3.
4.
To re-assign other device keys, repeat steps 1–4 and
substitute the key sequence using the following chart:
To Re-Assign
TV as 2nd DVD key
TV as 2nd Auxiliary key SETUP - 9 - 9 - 2 - AUX - TV
TV as 2nd Cable key
TV back to TV
DVD as 2nd TV key
DVD as 2nd Auxiliary key SETUP - 9 - 9 - 2 - AUX - DVD
DVD as 2nd Cable key
DVD back to DVD
AUX as 2nd TV key
AUX as 2nd VCR key
AUX as 2nd Cable key
AUX back to AUX
Upon completion of a re-assignment, the selected
M7820BP1.indd 16
NOTE: The remote control always defaults to
the CABLE mode after all devices are turned
off. Therefore, the initial power-on sequence
will always be TV, DVD, and an auxiliary
device, if no other device key is pressed first.
On the remote control, press AUX once.
Then press and hold SETUP until the AUX
key
blinks twice, then release SETUP.
Enter 9 - 9 - 2. The AUX key will blink twice.
Press AUX once. The AUX key will blink
twice.
The AUX key is now ready to be programmed
for your VCR. See Programming Device
Control on page 9.
Perform Key Sequence
SETUP - 9 - 9 - 2 - DVD - TV
SETUP - 9 - 9 - 2 - CABLE -TV
SETUP - 9 - 9 - 2 - TV - TV
SETUP - 9 - 9 - 2 - TV - DVD
SETUP - 9 - 9 - 2 - CBL- DVD
SETUP - 9 - 9 - 2 - DVD -DVD
SETUP - 9 - 9 - 2 - TV - AUX
SETUP - 9 - 9 - 2 - DVD - AUX
SETUP - 9 - 9 - 2 - CBL - AUX
SETUP - 9 - 9 - 2 - AUX - AUX
16
3/13/2007 3:54:01 PM