Air Filter - Tectro TP 20 Instrucciones De Uso

• The fan speed can be adjusted by pressing the
- Maximum setting.
- Medium setting.
- Lowest setting.
When the unit is switched off the most recent setting will be stored in
4
memory.
The timer function allows you to switch the unit on or off at a certain time.
5
TO SWITCH ON THE UNIT AT A CERTAIN TIME
• Ensure that the unit is set in the required operating mode
• Switch off the unit by pressing the
properly inserted into the wall outlet.
• Press the
• Use the
• When the set time has expired the unit will switch on.
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
• When the unit is operating in the required mode press the
The light "Timer set" will flash.
• Use the
• When the set time has expired the unit will switch off.
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.
D

AIR FILTER

The air conditioner is equipped with a screen mesh to filter dust particles from the
room air and to keep the internals of the unit clean.
With normal usage the screen mesh filter has to be cleaned every two weeks with
a vacuum cleaner. If the filter is not cleaned regularly the filter may block the air
flow.
Never use the air conditioner without the screen mesh filter!
-button. The light "Timer set" will flash.
and buttons to set a time between 1 and 12 hours.
and buttons to set a time between 1 and 12 hours.
-button
,
-button. Ensure that the plug is
-button.
4
49
of .