Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
GENERAL

SOUND ADJUSTMENT

VOLUME
Press VOLUME N or M. The volume level is displayed
as a number from 0 to MAX (25).
• The volume level is automatically set to 14 if the power is
turned off when the volume level is set to 15 or more.
(except when turning the power back on within 4
seconds)
To display the volume level when CD function is
selected
Press VOLUME N or M. The volume level is displayed
for 4 seconds.
DISPLAY on the remote control is also available.
3-mode equalizer
Press one of the 3-mode equalizer buttons and the
indicator of the selected setting lights up. To cancel, press
the selected setting.
ROCK - Emphasizes the high and low range of music.
POP - Emphasizes voice and midrange of music.
JAZZ - Emphasizes the low range of music.
When using the remote control, press EQ repeatedly until
the desired mode is selected.
The equalizer mode changes to ROCK, POP, JAZZ or no
equalization, cyclically.
QSOUND system
This system provides a rich, three dimensional sound area
for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
• At higher volumes, turning QSOUND on may cause
sound distortion. In this case, make the volume down.
DISPLAY
EQ
MICROPHONE MIXING
Connect a microphone with a mini plug to the MIC jack
and play a source to be mixed.
To record the microphone mixing sound, insert a tape in
deck 1 and press w REC.
• During dubbing at high speed, the microphone mixing
sound is not recorded.
MIC VOL – Adjusts the microphone volume. If a howling
sound is produced, turn the volume down.
• To prevent howling, hold the microphone away from the
speakers. The use of unidirectional type microphones is
also recommended.
Notes on CD-R/RW discs
• The unit may not play a CD-R/RW disc that is
recorded on personal computers or some kinds of
CD-R/RW recorders because of differences in
recording platforms.
• Do not attach any seal or label to either side (the
recordable side or the labeled side) of a CD-R/RW
disc. It may cause malfunction.
• Do not load an unrecorded CD-R/RW disc. It will take
over 30 seconds to read the disc. The disc may be
damaged if you try to open the disc compartment while
reading the disc.
To listen with the headphones
Connect headphones with a stereo mini plug to the PHONES
jack.
If an erroneous display or malfunction occurs
Make sure that none of the deck operation buttons is
pressed.
Press s while pressing POWER/6 STANDBY.
If the unit cannot be reset in the way above, disconnect the
AC cord and remove all the batteries to turn off the display.
Leave the unit for a while and turn the power back on.
En
E
F
D
I
NL
Pol
Hu
CZ
7
ENGLISH

Publicidad

Tabla de contenido
loading

Tabla de contenido