After Each Operation; Storing The Appliance; Transport; Storage - Kärcher IVC 60/30 Ap M Z22 Instrucciones De Uso

After each operation

Filter dedusting
 Pull the handle of the filter clean-off out
several times and reinsert it while the
appliance is turned off.
Empty the container
 Lock parking brakes.
Illustration
 Remove the pressure balancing at the
upper end.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration
 Pull the container out by the handle.
 Empty the container.
 Reinsert the container and lock it with
the push handle.
WARNING
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mechanism while
locking. Lock the container by pressing the
sliding bow with both hands.
 Plug in the pressure balancing.
Cleaning the device
 Vacuum and wipe the appliance inside
and outside with a damp cloth.

Storing the Appliance

 Coil the mains cable and store it.
 Wind the suction hose around the slid-
ing bow.
 Insert the floor nozzle and the suction
pipe into their respective holder.
 Place the appliance in a dry room and
secure it from unauthorized use.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Close the suction connection, see oper-
ating instructions.
 Release the park brakes and push the
appliance by the push handle.
 Grab the appliance by the chassis, not
by the sliding bow to load it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Dust extracting machines are safeguards
for the prevention or elimination of hazards
defined in the regulations of BGV A1.
– In order to carry out maintenance work,
the user must disassemble, clean and
service the unit, in so far as this is pos-
sible without endangering maintenance
personnel and other persons. Suitable
precautions include decontamination
before the unit is disassembled. Pre-
cautions must be taken for local filtered
forced air ventilation at the place where
the unit is disassembled, the cleaning of
the maintenance surface and suitable
protection of the personnel.
– The outside of the unit should be
cleaned thoroughly and any harmful
substances removed. Alternatively, a
sealed coating may be applied before
the unit is removed from the danger ar-
ea. All unit parts are to be considered
contaminated when they are removed
from the danger area. To avoid distribu-
tion of the dust, you must take the ap-
propriate measures.
– 6
EN

Storage

21