dwm40_bu_1609929990_t.fm5 Seite 7 Montag, 3. Juli 2000 3:5
Display Elements
a Angle display
b Battery indicator
c Spring angle indicator
d Corner angle indicator
e Miter angle indicator
f Bevel angle indicator
g Hold indicator
When the battery indicator (
measurements are still possible for approx.
1 – 2 hours.
When the indicator blinks, the batteries must
be replaced. Measurements are no longer
possible.
Area of Application
The unit is a precision tool for the measuring
and transferring of angles (horizontal/vertical),
e.g., for made-to-measure fabrication in inte-
rior construction, stairs construction, exterior
coverings, etc.
Spare Parts
Battery compartment cover . 1 609 203 928
End cap . . . . . . . . . . . . . . . . 1 609 203 770
Joint cover . . . . . . . . . . . . . . 1 609 203 927
Putting into Operation
Insert the batteries before putting into
operation for the first time.
Slide the battery compartment cover 4 in the
direction of the rectangle point and open.
When inserting the batteries, take care that
the polarization is correct (see Fig. B ).
The unit is automatically switched on after the
insertion of the batteries. For checking of the
display, all segments of the angle display ap-
pear for approx. 20 s. The current angle is
then displayed.
Switching On/Off
– On: Press button 11 .
All segments of the angle display appear
briefly.
– Off: Press button 11 again.
After 5 minutes without button actuation or
angle change, the unit switches off automati-
cally to preserve the batteries.
) appears,
– +
7