Cleaning And Maintenance - Bosch DWM 40 L Manual Del Usuario

dwm40_bu_1609929990_t.fm5 Seite 11 Montag, 3. Juli 2000 3:
Determining the Spring Angle
Tack the crown molding to the corner of a
table with the surface that will come in contact
with the wall as shown.
Place the folding leg flat against the underside
of the table and the base leg flat against the
back side of the crown molding.
The displayed angle corresponds to 180° mi-
nus the spring angle.
By pressing the BV/MT button, the spring an-
gle is automatically computed, stored and dis-
played for 3 seconds.
This entry is confirmed by the appearance of
"SPR" in the display.
To continue, see Section Measuring the Cor-
ner Angle .

Cleaning and Maintenance

Do not immerse the unit in water.
Wipe off dirt with a soft, damp cloth. Do not
use strong cleaning agents or solvents.
Check the unit from time to time for damage,
e.g., from dropping or shocks since deforma-
tion leads to erroneous measurement.
If the unit is exposed to rain for a longer time,
its performance can be degraded. After com-
pletely drying, the DWM 40 L is again fully
functional, however. A calibration is not nec-
essary.
Guarantee
Bosch products are guaranteed in accor-
dance with statutory/country-specific regula-
tions (proof of purchase by invoice or delivery
note).
Damage attributable to normal wear and tear,
overload or improper handling is excluded
from the guarantee.
In case of a claim, please send the complete-
ly assembled machine to your dealer or a
Bosch customer service center for power
tools.
11