Assembly And Operation; Removal And Installation Method Of Battery; Charging Method - Hitachi Koki WR 14DM Manual De Instrucciones

English

ASSEMBLY AND OPERATION

APPLICATIONS
Tightening and loosening of all types of bolts and nuts, used for securing structural
items.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Handle
Rechargeable
battery

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Rechargeable
battery
d
Fig. 4
12
Latch
Insert
Pull out
Fig. 3
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
Hole for
connecting the
rechargeable
battery
Pilot lamp
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you. (Fig.
3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch on the side of the battery.
(Fig. 3)
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical
cord if damaged. Have
it repaired immediately.