Intended Use | Installation | Operation; Installation | Operation | Safety - Cambium Networks ePMP Serie Guia De Inicio Rapido

Intended Use | Installation | Operation

The Cambium Networks ePMP radio products support data transmission over Point to Multipoint (PMP) and
Point to Point (PTP) microwave links. This radio equipment is intended for professional applications for fixed
outdoor installations only. These radios are available with an integrated antenna.
Connectorized units can operate with a selection of separately-purchased dual-polarity external antennas
through 2 x SMA-type female connectors. The installer is responsible to operate the radio equipment and the
accessories as intended and according to the description provided by the antenna manufacturer. The maximum
antenna gain allowed for external antennas is 25 dBi for subscriber modules and 17 dBi for access point sectors.
Installation and operation of this product is complex, and Cambium therefore recommends professional
installation and management of the system to ensure that operation complies with the regulations of the region
where the product is installed. Please follow the instructions in this leaflet. Further guidance on PMP / PTP
installation and operation is available in the product user guide.
The installer must have sufficient skills, knowledge and experience to perform the installation task and is
responsible for:
•
Familiarity with current applicable national regulations including radio regulations, electrical installation
regulations, surge protection regulations and 'working at heights' regulations
•
Installation in accordance with Cambium Networks instructions
•
Confirming that the equipment settings are compliant with national or regional regulations

Installation | Operation | Safety

Please observe the following important instructions during installation. This will set the equipment in compliance
with national regulatory regulations.
•
Ensure that the equipment is fitted with the latest firmware version (System Release 3.5.5 or 4.1.X or later).
The software is available from the Cambium Support Center web site.
•
During equipment set-up, verify that the correct region code is set (the region code is pre-set in the factory
for EU products) and then select the correct country code for the particular country where the product is
being deployed.
•
For connectorized units, enter the antenna gain into the 'Antenna Gain' setting under the 'Configuration >
Radio' menu.
Observe the following safety rules:
•
Ensure that the device and the structure to which it is mounted is capable of withstanding the maximum wind
speeds at a proposed site.
•
Always power down and unplug the equipment before servicing. The ePMP power supply is the primary
disconnect device.
•
Strong radio frequency (RF) fields will be present close to the antenna when the transmitter is on. Always
turn off the power to the device before undertaking maintenance activities in front of the antenna.
─
Observe the minimum safe distance limit for ePMP products provided below.
─
Ensure that equipment is installed in a position avoiding any radiation hazard to humans.
•
Exercise extreme care when working at heights. Observe national 'working at heights' regulations. Use trained
'competent' staff.
•
Exercise extreme care when working near power lines.
ePMP SERIES QUICK START GUIDE
5
English (UK, IE, NO)