Mounting; Configuration; Configuring The Management Pc; Conforming To The Limits - Cambium Networks ePMP Serie Guia De Inicio Rapido

Mounting

Refer to the Mounting ideogram

Configuration

Configuring the management PC

Select Properties for the Ethernet port. In Windows 7 this is found in Control Panel > Network and Internet >
Network Connections > Local Area Connection.
Select Internet Protocol (TCP/IP):
Click Properties.
Enter an IP address that is valid for the 169.254.X.X network, avoiding 169.254.0.0 and 169.254.1.1. A good
example is 169.254.1.3:
Enter a subnet mask of 255.255.0.0. Leave the default gateway blank.
Connecting to the PC and powering up
Check that the ODU ETH port is connected to the Ethernet + Power port of the power supply.
Connect the PC Ethernet port to the LAN port of the PSU using a standard (not crossed) Ethernet cable.
Apply mains or battery power to the PSU. The green Power LED should illuminate continuously.
Check that the ODU red Ethernet LED illuminates continuously.
Open a web browser and type: 169.254.1.1When prompted, enter admin/admin to login to the GUI and
complete the configuration.

Conforming to the limits

Ensure the link is configured to conform to local regulatory requirements by configuring the Country parameter
(located in the web management interface at Configuration > Radio > General).
When using connectorized devices with external antennas, also ensure that the antenna gain is configured
correctly in the device (the Antenna Gain parameter is located in the web management interface at
Configuration > Radio > Power Control).

Operating in the EU

In the EU, the 5 GHz ePMP products operate in the following frequency bands up to the maximum power shown:
Operating
EU Standard
Frequency Band
5470 – 5725 MHz
5725 – 5875 MHz
Note 1: Operation in the 5.8 GHz band is notpermitted in the following European countries: AT, BG, CZ, CY,
FR, HR, IT, LU, LV, NL, PL, TR. In other countries, government licenses may be required to allow
operation, please check your national government website.
Note 2 The radio applies national frequency allocations, power and DFS settings for each country code.
for mounting instructions.
Maximum Power
Limit (EIRP)
EN 301 893 1 Watt / 30 dBm
EN 302 502 4 Watts / 36 dBm
ePMP SERIES QUICK START GUIDE
Permitted usage
Available for general usage
within all EU nations
Permitted in some EU
nations, see notes 1 - 5
7
5 GHz units that
support this
frequency band
All EPMP
All EPMP