Rear-Facing Installation With Latch - Graco Comfort SPORT Manual De Instrucciones

REAR-FACING
1
LATCH belt must be routed through
opening in child restraint for
(see page 23, fig. k).
Belt must lay flat and not be twisted.
2
Adjust child restraint to recline position
(see fig. a and pages 18 and 19, fig. b) Place
rear-facing on vehicle seat equipped with
LATCH anchors.
3
For ease of installation, extend
to its maximum length.
4
Hook connectors to vehicle lower anchors
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. c).
5 Press down firmly in center of child restraint
while pulling LATCH
8
INSTALLATION WITH
rear-facing mode.
LATCH belt
adjustment belt. (fig. d).
LATCH
6
Pull front to back and left to right to check for
secure installation (fig. e).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service
(see back cover).
7 Check level indicator on child restraint.
Vehicle must be on level ground and child in
child restraint when checking level indicator.
Ball MUST be entirely in green zone (fig. f). If
necessary, place rolled towels under child
restraint, at vehicle seat crease, until entire ball
is in green zone. Then re-check level indicator.
DO NOT use tether rear-facing. Tether must
be stored (see "Tether Storage" page 32).
Periodically check that child restraint is
securely installed and properly leveled; adjust
if necessary.