HQ-Power EXCALIBOR II Manual Del Usuario página 5

b. DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDPL3601MHW10. Multiple VDPL3601MHW10s can be linked through serial linking. The
linking cable should be a two-core screened cable with XLR input and output connectors.
Pin assignment: pin 1: shield – pin 2: data+ – pin 3: data-
c. DMX512 Chain with Termination
d. Projector DMX Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDPL3601MHW10.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDPL3601MHW10 will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel
will only affect the device in question.
For the 10-channel VDPL3601MHW10, you will have to set the start address of the first VDPL3601MHW10 to 1, the
second VDPL3601MHW10 to 11 (1 + 10), the third to 21 (11 + 10) and so on.
6. Use
Please refer to the second page of this manual for a complete menu diagram.
a. Manual Mode
1 RGB dimmer
2 Red dimmer
Green dimmer
3
4 Blue dimmer
5 Vertical moving angle (tilt)
Horizontal moving angle (pan)
6
b. Auto Mode
1 Automatic 7-colour fade in and fade out
7-colour transition
2
3 7-colour fading
c. Sound-Controlled Mode
7-colour fading
1
2 7-colour transition
VDPL3601MHW10
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
5 HQPOWER