Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
10.
problem
no light, no alarm
backup time less
than rating
Battery
11.
• To replace the battery, switch the UPS off and unplug all the power cords (mains and
connected devices).
• Remove the top cover of the UPS by releasing the four screws.
• Disconnect the terminals. Be extremely careful not to touch any other terminals or wires
inside the housing.
• Remove the battery from the housing and replace it with and identical type of battery (use a
WPE7.2-12).
• Connect the terminals following the right polarity.
• Re-install the top cover and secure it with the 4 screws.
Dispose of batteries in accordance with local regulations.
Do not try to open the battery housing.
Do not throw batteries in fire as they may explode.
Keep batteries away from children.
Technical specifications
12.
input voltage
input frequency
back-up time
connections
optional power cables (not incl.)
beeping alarm
spare battery
power capacity
weight
dimensions
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use of this
device.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
00 (26/11/2008)
possible cause
power switch off
loose power cord
circuit breaker active
battery not fully charged
battery end of life
charger defective
230Vac +/- 25%
50Hz
1.5 ~ 15 minutes depending on connected load
4x IEC-320 C13 (CEE 22) outlets
2x RJ-45 modular sockets for telephone line/network
protection
1x USB connector for software communication with PC
NET3B (1.8m), NET3B3M (3m)
in case of battery on, low battery and overload
WPE7.2-12
600VA
7.5kg
325 x 120 x 140mm
UPS600N1
press the power switch [A]
plug power cord firmly in wall socket
check load on UPS and press the circuit
breaker [G]
recharge battery for at least 6 hours
replace battery
contact your local dealer
6
solution
®
Velleman
Publicidad
