HQ-Power VDPLOC Manual Del Usuario página 5

6. Use
• Setup
Connect the strips using the supplied 5-pin XLR cables.
• Stand-Alone Mode
Press the mode button to view the chase menu. Select chases 1 ~9 using the up or down button. Chases 1 ~ 8
run according to the fade and speed value. Chase 9 is sound-activated.
Adjust the chase fade time from 0 ~ 100% F100
Adjust the chase speed from 0 ~ 500 steps S030
• Manual RGB Adjustment
Press the mode button and select the manual RGB adjustment menu. Press F / S to select the desired colours.
Use up or down to adjust the value.
¯ 000 → ¯ 255 RED from 0 ~ 100%.
-000 → -255 GREEN from 0 ~ 100%.
_000 → _255 BLUE from 0 ~ 100%.
The last used setting will be memorized.
• Sound-Active Mode
In stand-alone mode, select chase 9 and adjust the audio input level using the sensitivity control dial on the side
panel of the controller. In DMX mode, use channel 6 to select the sound-active mode.
A001
• DMX Mode
Press the mode button to view the DMX address setting menu A001. Select the DMX starting address using the
up or down button. Select the DMX channel mode by pressing the mode button to view Ndl1. Now, press F / S to
enter; use up or down to select.
Chn6
Channel 1 Rainbow
Channel 2 Red (0 ~255)
Channel 3 Green (0 ~255)
Channel 4 Blue (0 ~255)
Channel 5 Strobe (1 ~ 20Hz)
Channel 6 Sound-active
There are 8 self-running programs (value: 1 ~ 240) and one sound-active program (value: 241 ~ 255) in channel
6.
Chase 1
Chase 2
Chase 3
Chase 4
Sound-active
VDPLOC
chE1
MAnu
6-Channel Mode
1 ~ 30
31 ~ 60
61 ~ 90
91 ~ 120
241 ~ 255
Chn3
Channel 1 Red (0 ~255)
Channel 2 Green (0 ~255)
Channel 3 Blue (0 ~255)
Chase 5 121 ~ 150
Chase 6 151 ~ 180
Chase 7 181 ~ 210
Chase 8 211 ~ 240
5
3-Channel Mode
HQPOWER