Initial Use; Inserting/Exchanging Batteries; Using The Measuring Tape - Powerfix Profi PLW 3 A1 Instrucciones De Uso

Nivel de burbuja con láser
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Initial use/Using the measuring tape

Initial use

Inserting/exchanging batteries

Loosen the screw of the battery compartment cover with a crosshead screw-
driver and remove the battery compartment cover.
Insert the 2 Type AAA/Micro batteries resp. replace the used batteries with
new ones.
Pay heed to the correct polarity, as shown in the battery compartment
Replace the battery compartment cover and retighten the screw.

Using the measuring tape

WARNING
The measuring tape retracts automatically.
Do not allow the measuring tape
guide it back by hand. There is also a risk of personal injury!
NOTICE
With the measuring tape
the metric system or in the Anglo/American system. The upper scale shows
lengths in feet and inches, the lower scale in meters and centimeters.
Slide the restrainer
Pull the measuring tape
Secure the measuring tape
When you roll the measuring tape
new length, hold the end fi rmly and slide the restrainer
UNLOCK.
Now allow the measuring tape
PLW 3 A1
PLW 3 A1
to rewind itself without control, instead,
you can read off measurements of length in
to the position UNLOCK.
2
out to the required length.
, by sliding the restrainer
back up or wish to adjust it to a
to roll back slowly, without releasing it.
.
7
to the position LOCK.
2
to the position
2
29
29
GB
MT

Publicidad

Tabla de contenido
loading

Tabla de contenido