Tabla de contenido
Publicidad
The following information relates to protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this
information, we use the following symbols. Please read the manual and pay attention to these sections.
– A POTENTIAL HAZARD THAT WILL CAUSE SERIOUS INJURY OR LOSS OF LIFE.
DANGER:
WARNING:
– A POTENTIAL HAZARD THAT COULD CAUSE SERIOUS INJURY OR LOSS OF LIFE.
CAUTION:
– A POTENTIAL HAZARD THAT MAY CAUSE MODERATE INJURY OR DAMAGE TO EQUIPMENT.
WARNING
1.
RISK OF FIRE OR EXPLOSION. Never spray flammable
liquids in a confined area. It is normal for the motor
and pressure switch to produce sparks while
operating. If sparks come into contact with vapors
from gasoline or other solvents, they may ignite,
causing fire or explosion. Always operate the
compressor in a well–ventilated area. Do not smoke
while spraying. Do not spray where sparks or flame
are present. Keep compressor as far from spray area
as possible.
2.
RISK OF BURSTING. Rust can weaken the tank. Drain
the condensed water from the tank after each use to
reduce rusting. If a leak is detected in the tank,
replace the tank immediately. Do not weld, drill or
modify the air tank of this compressor. Welding or
modifications on the air compressor tank can severely
impair tank strength and cause an extremely
hazardous condition. Welding or modifying the tank in
any manner will void the warranty.
3.
RISK OF ELECTRICAL SHOCK. A licensed electrician in
accordance with all local and national codes must
install all wiring. Never use an electric air compressor
outdoors when it is raining or on a wet surface, as it
may cause an electric shock.
4.
RISK OF INJURY. This unit starts automatically. ALWAYS
shut off the compressor, remove the plug from the
outlet, and bleed all pressure from the system before
servicing the compressor, and when the compressor
is not in use. Do not use the unit with
the shrouds or beltguard removed. Serious injury
could occur from contact with moving parts.
5.
RISK OF BURSTING. Check the manufacturer's maximum
pressure rating for air tools and accessories.
Compressor outlet pressure must be regulated so as
to never exceed the maximum pressure rating of the
tool. Relieve all pressure through the hose before
attaching or removing accessories.
6.
RISK OF BURNS. High temperatures are generated
by the pump and manifold. To prevent burns or other
injuries, DO NOT touch the pump, manifold or transfer
tube while the pump is running. Allow them to cool
before handling or servicing. Keep children away
from the compressor at all times.
7.
RISK TO BREATHING. Be certain to read all labels
when you are spraying paints or toxic materials, and
follow the safety instructions. Use a respirator mask if
there is a chance of inhaling anything you are
spraying. Read all instructions and be sure that your
respirator mask will protect you.
8.
RISK OF EYE INJURY. Always wear ANSI Z87.1
approved safety goggles when using an air
compressor. Never point any nozzle or sprayer toward
a person or any part of the body. Equipment can
cause serious injury if the spray penetrates the skin.
9.
RISK OF BURSTING. Do not adjust the pressure switch or
relief valve for any reason. Doing so voids all
warranties. They have been preset at the factory for
200-2785
SAFETY GUIDELINES
the maximum pressure of this unit. Personal injury
and/or property damage may result if the pressure
switch or the relief valve are tampered with.
10. RISK OF BURSTING. Do not use plastic or pvc pipe for
compressed air. Use only galvanized steel pipe and
fittings for compressed air distribution lines.
11. RISK TO HEARING. Always wear hearing protection when
using an air compressor. Failure to do so may result
in hearing loss.
12. RISK TO BREATHING. Never directly inhale the
compressed air produced by a compressor. It is not
suitable for breathing purposes.
13. The power cord on this product contains lead, a
chemical known to the State of California to cause
cancer, and birth defects or other reproductive harm.
Wash hands after handling.
NOTE: ELECTRICAL WIRING. Refer to the air compressor's
serial label for the unit's voltage and amperage requirements.
Ensure that all wiring is done by a licensed electrician, in
accordance with the National Electrical code.
CAUTION
1.
Drain the moisture from the tank on a daily basis. A clean,
dry tank will help prevent corrosion.
2.
Pull the pressure relief valve ring daily to ensure that the
valve is functioning properly, and to clear the valve of any
possible obstructions.
3.
To provide proper ventilation for cooling, the compressor
must be kept a minimum of 12 inches (31 cm) from the
nearest wall, in a well–ventilated area.
4.
Fasten the compressor down securely if transporting is
necessary. Pressure must be released from the tank
before transporting.
5.
Protect the air hose and electric cord from damage and
puncture. Inspect them weekly for weak or worn spots,
and replace if necessary.
6.
To reduce the risk of electric shock, do not expose to rain.
Store indoors.
7.
Never operate the compressor if the power cord or plug
are damaged. Take the equipment to the nearest
Authorized Service Center , and a specialist technician
will replace it.
WARNING
This product contains chemicals known to the State of
California to cause cancer, birth defects and/or reproductive
harm.
CALIFORNIA PROPOSITION 65 WARNING:
3
Publicidad
Tabla de contenido
