Prepare The Receiver Collar; To Insert And Remove The Battery - Petsafe PIG19 Manual De Funcionamiento Y De Adiestramiento

STEP 5

Prepare the Receiver Collar

There are two sets of Contact Points that can be used on your Receiver Collar. Your Receiver
Collar comes with the short Contact Points installed. The longer Contact Points should be used
on dogs with long hair. Tighten the Contact Points using Test Light Tool (5A) one-half turn
beyond finger tight. Check the tightness weekly.

To Insert and Remove the Battery

Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilises a replaceable PetSafe
is designed to make battery replacement easier and increase water protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver Collar (triangle)
(5B). Use the edge of the Test Light Tool to turn the battery clockwise until the arrow lines up
with the lock symbol on the housing.
To remove the battery, turn the battery anti-clockwise using the edge of the Test Light Tool
(5C). DO NOT attempt to cut into or pry open the battery. Be sure to discard the used
battery properly. Battery life will vary depending on how often your pet tests the system and
receives a Static Stimulation. Check the Receiver Collar every month to ensure the battery is
working properly.
If the Receiver Indicator Light is flashing every 4 to 5 seconds, battery replacement is
required. Remove the old battery from the Receiver Collar. Discharge all power by holding
the stimulation level button down until the LED light is no longer illuminated. Replace with a
new battery.
A replacement PetSafe battery (RFA-67D-11) can be found at many retailers. Contact the Customer Care Centre or visit our
®
web site at www.petsafe.net to locate a retailer near you.
To Set the Static Stimulation Level
Read all steps before attempting to set the
Static Stimulation Level.
1. Remove the clear plastic cover with the Test Light Tool
to expose the Stimulation Level Button (5D).
2. With the battery installed, press the Stimulation Level
Button and release when the Receiver Indicator Light
turns on (5E).
3. The Receiver Indicator Light will emit a series of flashes
representing the Static Stimulation Level.
4. Increase the Static Stimulation Level by pressing and
releasing the Stimulation Level Button within 5 seconds
of the previous series of flashes.
5. After setting the Static Stimulation Level, replace the
cover to protect the Stimulation Level Button.
The Static Stimulation levels increase in strength from
1 to 5. Pressing the Stimulation Level Button while the
Receiver Collar is on level 5 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to
choose the Static Stimulation level that best fits your pet.
The Receiver Collar is equipped to automatically increase the level of Static Stimulation the longer your pet remains in the Static
Stimulation Zone if the collar is set at level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, flashing every 4 to 5 seconds when replacement is required.
battery (RFA-67D-11). This unique battery
®
5D
www.petsafe.net
5A
5B
5C
5E
13