Maintenance And Care - Clatronic HSM-R 2687 Instrucciones De Servicio

5....-05-HSM-R 2687 Neu
AC/DC mode and battery mode
GB
The hair and beard cutting machine can be used either connected to the mains
with the adapter or in battery mode after being charged. For DIRECT CONNEC-
TION MODE insert the plug of the adapter into a 230V/50Hz socket, insert the
connection cable into the connection socket located on the hair clipper and place
the function selector to ON. The machine is pre-charged ex works. Please charge
up the device for 12 hours before initial use. The maximum length of the subse-
quent charge cycles is approximately 8 hours. When fully charged the device has a
maximum operating time of 25 minutes. After this time it must be switched off and
allowed to cool down for 10 minutes. The charging LED lights up during the char-
ging procedure.
Useful tips regarding battery life
Battery life can be lengthened by paying attention to the following instructions:
• Wait until the battery is almost completely flat before recharging.
• Never leave the machine connected to the charger for more than 24 hours.
• Charge the machine only with room temperature between 0 and +40°C.
Beard trimming and cutting
• Shift the selector (2) to the ON position. Start with the longest cutting level and
trim your beard gradually to the desired length.
Note: Lock the selected cutting length (cutting length comb) in position with the
locking switch located on the back of the housing (position 8 – „lock").
Hair cutting/thinning
• Shift the selector (2) to the ON position. Start with the longest cutting level and
shorten the hair gradually to the desired length.
Note: Lock the selected cutting length (cutting length comb) in position with the
locking switch located on the back of the housing (position 8 – „lock").
Contour cutting and neck shaving
• Remove the cutting length comb (3) and shift the selector (2) to the ON position.
• The shearing head enables the precise trimming of the beard contours even
areas, which are difficult to reach, and a clean shaving of the hairline in the neck
area.
The regular cleaning and maintenance of the machine will guarantee optimal
results and a long life.
• Use only a slightly damp and soft cloth to clean the machine.
• After use remove each time all hair left on the machine with the supplied brush.
• Remove the cutting comb and the cutting head to either blow off the hair
particles or brush them off with the cleaning brush.
28
05.11.2003 10:26 Uhr

Maintenance and care

Seite 28