Rear Panel Layout - VOX Amplification AGA4-AT Manual De Usuario

1. AUX IN Jack
Connect keyboards and audio equipment with a mini-phone plug (unbalance) to this terminal.
Adjust the input volume on the connected instrument.
2. MAINS INPUT
Connect your supplied mains power lead here.
NOTE: Use only the power cable that is included with the AGA4-AT. Using another power cable may
cause malfunctions.
The specific mains input voltage rating that your amplifier needs to run at is located on the rear panel
of your amplifier. Before making any connections or powering up the amplifier, make sure the correct
voltage is set. If you have any doubt, refer to your local VOX dealer.
Controls:
Inputs:
Tube compliment
Output Power:
Speaker:
Dimensions (W x D x H):
Weight:
Accessory:
*Specifications and appearance are subject to change without notice for improvement.
4

REAR PANEL LAYOUT

1
SPECIFICATION
Reverb, Volume, Tone
INPUT Jack, AUX IN Jack
1 x 12AX7, 1 x EL84
4 W RMS (16Ω)
6. 5 inches (16Ω)
260 x 195 x 280 mm /10.24 x 7.68 x 11.02 inches
6.0 kg / 13.23 lbs
Power Cable, Manual
2