Fax +32 2 359 95 50
12. Before unscrewing the boiler drain screw, wait until the generator
is cold (unplugged for more than 2 hours). Never fill the boiler
through the boiler drainage hole (except for rinsing).
13. Do not direct steam at people, animals or iron clothes while they
are being worn.
14. Deposit or Mineral in tap water will generate lime and eventually
block the steam holes, therefore it is advisable to use distilled
water.
15. Always put the iron with the soleplate down on the iron rest, never
resting on its heel.
16. The use of accessory attachments is not recommended by
manufacturer and may result in fire, electric shock or personal
injury.
17. The iron is not to be used if it has been dropped, if there are
visible signs of damage or if it is leaking.
18. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agency or similarly qualified persons in
order to avoid a hazard.
19. The iron must be used and rest on a stable surface.
20. When placing the iron on its stand, ensure that the surface on
which the stand is placed is stable.
SPECIAL INSTRUCTIONS
1. This is a 1750W appliance. To avoid a circuit overload, do not
operate another high wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 15-ampere cord
should be used. Cords rated for less amperage may overheat.
Care should be taken to arrange the cord so that it cannot be
pulled or tripped over.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
POLARIZED PLUG INSTRUCTIONS
This appliances is equipped with a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug will fit
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
3
Assembly page 3/36
USK SIS 32968 - 100420