Filling The Water Tank - Kalorik SIS 32968 Manual De Instrucciones

Fax +32 2 359 95 50
•
When steam-ironing woolen fabrics, shining of the fabric may
occur. This can be prevented by turning the article inside out and
ironing the inside or by interposing a light damp cloth.
•
Velvet and other textures that rapidly acquire shiny spots should
be ironed in one direction only (with the nap), applying only light
pressure. On these fabrics, always keep the iron moving.
•
Iron the reverse side of synthetic materials and silk, it is not
advisable to use steam as this may cause stains.
•
When you have been ironing fabrics at a high setting, do not iron
articles that require a lower temperature (such as nylon...)
immediately afterwards. Adjust the selector switch to a lower
setting and wait until iron has cooled down to the desired
temperature.
DRY PRESSING
•
Plug in the appliance. Turn the variable steam dial to position
•
Plug in the iron switch (10).
•
Set the temperature dial for the desired fabric. Always check the
label of the garment before choosing the temperature setting.
•
Let the iron on its rest and wait until the temperature indicator
light goes out before starting ironing.
•
Do not press the switch (1)

FILLING THE WATER TANK

•
Put the base on a stable, horizontal and heat resistant surface.
•
Pull out the water tank and slide it forward. Fill the water tank with
clear water up to its "Max" level.
•
Put the water tank back in the base correctly by sliding it
backward until it is locked.
•
Never add vinegar, detergents or other chemical products to the
water as this would damage the appliance, during normal use.
See Cleaning section for more details.
•
Do not use the water tank without a filter (13). The connecting
elbow (14) needs to face the external side, towards the boiler unit.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
7
Assembly page 7/36
.
USK SIS 32968 - 100420