Swivel Function; Overheating Protection; Safety Switch; Frost Monitor - Silvercrest SHLF 2000 B2 Instrucciones De Servicio

1. Press the button 24 in order to ad-
just the timer setting.
The hour indicator flashes.
2. Press the button + 20/- 22 in order to
set the hours.
3. Press the button 24.
4. Press the button + 20/- 22 in order to
set the minutes.
5. Press the button 24 in order to start
the timer.
NOTE: by keeping the buttons + 20 or - 22
pressed, the values toggle until you release the
button.
The selected running time is shown on the
display 10.

6.5 Swivel function

The device has a swivel function.
It causes the device to swivel to and fro, thus
distributing the escaping air more evenly in
the room.
• By pressing button
switch the swivel function on and off.

6.6 Overheating protection

This device possesses overheating protec-
tion for your safety.
If the temperature inside the device becomes
too high, it automatically switches off:
1. Switch the device off by setting the main
switch 9 to 0.
2. Check whether the air inlet or air outlet
are obstructed and eliminate the cause.
If the cause cannot be found and the
fault occurs repeatedly, have the device
repaired or take it out of operation.
3. Wait for the device to cool down.
4. Then you can continue to use it normally.
52 GB

6.7 Safety switch

A safety switch 4 protects the device against
damage caused from falling over.
The safety switch 4 is positioned on the un-
derside of the device and switches it off im-
mediately in the even of it falling over.
1. Place the device back into upright posi-
tion.
2. Select the desired function again.

6.8 Frost monitor

The device has a so-called frost monitor func-
tion. If this function is activated, the device
switches on automatically, as soon as the
ambient temperature falls down to 6 °C. The
device remains switched on until an ambient
temperature of 9 °C has been reached.
• Press the button Mode 21 until the sym-
bol
frost monitor function is switched on.
• Press the button Mode 21 once and
25, you can the symbol
monitor is switched off.
NOTE: high electricity costs when in
continuous operation.
Please observe that a lot of electrici-
ty is consumed in continuous opera-
tion (24 hours) due to the high
output of 2,000 watt. At a price of
€0.25 per kilowatt hour, this would
lead to costs of €12 per day or €360
per month.
31 appears on the display. The
31 disappears. The frost