EGO POWER MOWER Manual Del Operador página 13

DANGER: Rotating blades can cause serious injury.
To prevent serious injury, remove the safety key when
the mower is unattended, or when adjusting, cleaning,
servicing, transporting, lifting, or storing the mower.
To Start (Fig. Q)
1) Attach the battery pack to the mower, insert the safety
key into the key slot and close the battery cover (Fig. O).
2) According to Fig. P, depress the switch button down.
3) With the switch button depressed, pull the bail switch
upward to the handle and release the switch button.
To Stop (Fig. R)
1) Fully release the bail switch.
2) The electric brake in the Automatic Braking
Mechanism will stop the blade rotation within 3
seconds of the bail switch release.
VARIABLE-SPEED SELF-PROPEL SYSTEM (only
model LM2010E-SP)
LM2010E-SP mower is equipped with variable-speed
self-propel capability. This system is independent of the
blade On-Off switch; it is not dependent on blade rotation.
To operate the system without blade rotation, pull the
self-propel lever to the handle.
To turn the self propel off, release the self-propel lever.
The system has variable speed. To increase the speed,
move the self-propel speed-control lever forwards. To
decrease the speed, move the self-propel speed-control
lever backwards (Fig. S).
To operate with the blade rotating for cutting:
1. Start the mower.
2. While holding the bail switch against the handle with
left hand, pull the self-propel lever to the handle with
your right hand.
3. Hold both the bail switch and the self-propel lever
simultaneously against the handle with your right
hand and use your left hand to adjust the self-propel
speed-control lever to choose a proper speed.
WARNING:
To reduce the risk of injury, never attempt
to override the operation of the switch or self propel system.
Use the self propel for its intended purpose only.
LED HEADLIGHTS (Fig. A-12)
Press the switch button (Fig. D-21) to turn on/off the LED
headlights in the front of the battery compartment.
POWER INDICATOR ON THE MOWER (Fig. D-22)
The mower is equipped with a power indicator to indicate
the charge level of the battery pack and the working
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2010E/LM2010E-SP
status of the mower. The power indicator will illuminate
when the blade is rotating or when the LED headlights are
turned on.
Power
Indicator Meaning Action
on Mower
Mower is working
Shining properly; battery
N/A
green has at least 15%
of its charge
Stop the mower and
Shining red Low battery
charge the battery pack
The battery is Stop the mower and
Flashing red
nearly depleted charge the battery pack
Remove the battery
The mower or the from the mower, move
Shining
battery pack is them to the shade and
orange
overheated cool them at least 15
minutes
Slow down your pace
Flashing The mower is or raise up the cut
orange overloaded height to decrease
the load
MOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too
much grass at one time. Slow down your cutting pace or
raise the cut height.
Your mower has built-in overload circuit protection. When
the mower is overloaded, the motor will stop and the
power indicator on the mower will flash orange. Remove
the battery pack from the mower. Check to see if grass
has collected beneath the deck and clear it if necessary,
then install the battery and restart the mower.
BATTERY HIGH TEMPERATURE PROTECTION
The battery pack will generate heat during operation. The
heat dissipates more slowly in hot weather. If the battery
temperature exceeds 70°C during operation, the protection
circuit will immediately turn off the mower to protect the
battery pack from damage. The power indicator on the
mower will shine orange and the LED on the battery will
flash orange. Release the bail handle, wait until the battery
pack cools down to approximately 67°C , then restart the
mower.
MAINTENANCE
EN
13