Securing The Drill Stand With Jack Screw; Adjusting The Depth Gauge (When Using The Drill Stand) - Hilti DD 150-U Manual De Instrucciones Original

1. Turn all the leveling screws until they project approx. 5 mm underneath the base plate.
2. Connect the vacuum connector on the vacuum base plate to the vacuum pump.
3. Locate the center point of the hole to be drilled. Draw a line from the center of the hole to be drilled in
the direction in which the machine is to be positioned.
4. Make a mark on the line at the specified distance from the center of the hole to be drilled.
Technical data
Combination base plate
Vacuum base plate
5. Switch on the vacuum pump and press and hold down the vacuum release valve.
6. Line up the mark on the base plate with the line.
7. When the diamond core drilling machine is correctly positioned, release the vacuum release valve and
press the base plate against the work surface.
8. Use the leveling screws to level the base plate.
9. Make sure that the diamond core drilling machine is secure.
5.3

Securing the drill stand with jack screw

1. Secure the jack screw to the top end of the rail.
2. Position the drill stand on the work surface.
3. Use the 4 leveling screws to level the base plate.
4. Use the jack screw to apply tension to the drill stand and tighten the locknut on the jack screw.
5. Make sure that the diamond core drilling machine is secure.
5.4 Fitting the hand wheel
The hand wheel can be fitted on either side of the drill stand.
▶ Fit the hand wheel on to the shaft.
▶ Secure the hand wheel.
5.5 Fitting the side handle
1. Turn the side handle to release or secure it, as applicable.
2. Check that the side handle is fitted correctly and tightened securely.
5.6 Adjusting the side handle
1. Slacken the side handle by turning it counter-clockwise.
2. Position the side handle.
3. Secure the side handle by turning it clockwise.
4. Check to ensure that the side handle is tightened securely.
5.7

Adjusting the depth gauge (when using the drill stand)

1. Adjust the depth gauge.
2. Secure the depth gauge by tightening the clamping screw.
5.8 Securing the diamond core drilling machine in the drill stand
1. Turn the hand wheel counter-clockwise and pull the locking pin out.
2. Engage the interface plate on to the hook on the drill stand.
3. Push the locking pin in and use the hand wheel to tighten it securely (turn clockwise).
4. Insert the switch locking device into the grip.
The switch locking device can be used to lock the on/off switch in the "on" position for sustained
operation.
5. Close the water valve in the side handle.
6. Connect the water supply.
*434949*
Printed: 05.02.2019 | Doc-Nr: PUB / 5069546 / 000 / 06
6
4
4
434949
290 mm
290 mm
7
English 35