Usb Mode; Cleaning And Maintenance - Brandt BBTS-2000BW Manual De Instrucciones

To preset stations
You can save up to 20 FM radio stations to the memory.
1. Tune in to the station to be preset.
2. Press and hold until "P01" flashes on the display.
3. Repeatedly press / to select the preset number where you want to save the station.
4. Press to store the station into the selected preset number.
5. Repeat the above steps to save all the desired stations.
To listen to a preset station,
Press and then press / to select a preset station.

USB MODE

Inserting and removing a USB memory device
Carefully insert a USB memory device into the USB port. To remove the USB memory device
simply pull the device out.
Selecting USB mode
1. When the unit is turned on, repeatedly press S to select the USB mode.
The display will show "USb" briefly and then the playback will start automatically.
2. During playback, press and hold / to search through the track backward or forward.
3. During playback, repeatedly press / to go to the previous or next track.
4. To pause, press . To resume play, press again.
+ -
5. Adjust the volume level by repeatedly pressing / .
LINE IN MODE
1. Connect the speaker to any device with a headphone/earphone jack or line out using a 3.5
mm audio cable.
2. When the unit is turned on, repeatedly press S to select the Line in mode.
• The display will show "LinE".
3. Operate the device as usual. The sound will be heard from the speaker.

CLEANING AND MAINTENANCE

Clean the unit with a soft, slightly damp cloth and wipe it with a dry cloth.
Never immerse it in water.
Do not use abrasive or chemical cleaning agents.
EN-4