Publicidad
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Belt adjustment TRR 280
1
Image
merely illustrative
Attaching the Machine 2-Clamp Clutch Bar
1
2
5
2
4
3
When using the equipment
Check if rotation direction is correct.
Only shred wood and plant waste of proper
dimensions.
Wear proper clothes and safety equipment.
Make sure you have enough fuel in the tractor to
avoid a forced stop when using the TRR 280.
2
3
4
to the Tractor
Image
merely illustrative
Operation Instructions
Loosen the screws and remove the belt guard;
Loosen the screws (1) of the gearbox (2);
Then loosen the nut (3) to be able to move the
gearbox (2) by the screw (4), becomes the proper
belt tension;
After tightening the belt tightening the nut (3) and
screws (1).
The machine attachment bar on the tractor is
supplied disassembled. To mount the bar on the
machine, follow these instructions:
Remove the tractor lower clutch bar (5) from its
O
packaging and, using the screw (1), flat washer
(2), lock washer (3) and nut (4), secure the bar
to the hole in the machine frame.
Then tighten the screw according to the torque
O
table shown in this manual.
Only use shredder in safe conditions, well lit and
ventilated areas.
Push small materials toward the blades using long
pieces of wood and avoid touching the inlet funnel.
Small wood fragments must be slowly pushed,
longitudinally, to prevent chips from being
thrown against the operator.
67
Publicidad
