Wall Mounting Instructions; Mounting The Spacer & Wall Brackets; Mounting Unit On Brackets; Mounting Hose Hanger Bracket - Mi-T-M Corporation CAW-2004-0ME1 Manual De Operador

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

MOUNTING THE SPACER & WALL BRACKETS:

Using the hole pattern for the unit being installed, mark and drill the holes. Mount the Spacer Bracket (2) to the wall

in the top set of holes. Mount the Wall Mount Brackets (1) to the wall in the bottom set of holes.

Figure 5: Mounting Unit on Spacer Bracket (2)

MOUNTING UNIT ON BRACKETS:

Using proper personnel and/or equipment to lift unit, set the unit on the Spacer Bracket (2). Continue to hold unit up

while the baseplate is bolted to the Spacer Bracket using Items 4, 5 & 6 provided. These may be left loose until all

nuts and bolts are started. Secure the Wall Mount Brackets (1) to the baseplate using the remaining nuts and bolts

(4, 5 &6). Tighten all nuts and bolts. Check to be sure the unit is secure before operating.

CAUTION: These units can be heavy, ensure proper personnel and/or equipment is available for lifting and

securing!

MOUNTING HOSE HANGER BRACKET:

The Hose Hanger Bracket (3) may be mounted to any of the 2.50" x 1.25" rectangular hole sets on the front of the

Unit's Baseplate or the bottom of the Wall Mount Brackets (1). For ease of mounting, two bolts may be put through

the lower right and upper left holes to keep unit more secure while

mounting the Hose Hanger Bracket. It is recommended that washers

not be used on those bolts. Slip the Hose Hanger Bracket over the bolt

heads of the first two bolts and line up with the other two holes and bolt

them in.

NOTE: The two bolts in the upper right and lower left of the hole

set where the Hose Hanger Bracket (3) is mounted may need

to be longer to compensate for the extra material thickness.

This hardware is unique to each installation will need to be

obtained by the installer prior to installation.

MOUNTING ELECTRIC BOX:

Using the hole pattern for the Electric Box being installed, mark and

drill the holes. Locate Electric Box in a convienient location on the wall

for easy access and troubleshooting.