Rear Panel; Dmx Values; Connecting The Unit - Work Pro W VMX 4 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN

REAR PANEL

1
1. Mains Supply: Connect the IEC-Schuko cable on this point and in a mains supply outlet with the correct voltage.
protection fuse. In case of fuse blowing, replace it by an identical rate.
2. DMX signal input: 3-pin XLR 3 pin connection. It allows to connect the device to a DMX network and, through one DMX channel,
to switch the chosen video input to the output.
3. Composite Video + Audio output interface: RCA standard connection. The yellow color connector is for video signal. The white
and red connectors are for audio signal (L+R).
4. Composite Video + Audio input interface: RCA standard connection. The yellow color connector is for video signal. The white
and red connectors are for audio signal (L+R). This connection is common for all 4 inputs.
DISPLAY
wmx-4
addr:002 ch:ch_1
1
1. Selected DMX channel.
2. Chosen and sent input to the output.
3. A flickering "D" shows that the unit is receiving DMX frames.

CONNECTING THE UNIT

Composite video and
Audio (L+R) output
VMX 4
User Manual
2
d
2
ch:none
3
4
0 - 24
3
25 - 74
75 - 124
125 - 174
175 - 255
(No channel selected)
DMX frame
(1 control channel)
Page 3
It incorporates a

DMX VALUES

(0-9%)
Without channel selection
(10-29%)
CH_1 selected
(30-49%)
CH_2 selected
(50-68%)
CH_3 selected
(69-100%)
CH_4 selected
Input 2
Input 3
Input 4
Input 1

Publicidad

Tabla de contenido
loading

Tabla de contenido