Plantronics Vista M12 Manual Del Usuario página 12

set default
3
S T E P
s e t t i n g s
These are the default settings for
headset use.
1. Headset /Handset Selector is depressed
(colored indicator showing).
2. Mute Switch is released (no colored
indicator showing).
3. Incoming Volume Thumbwheel is set to 4.
4. The Outgoing volume has been pre-set. You
can adjust it when you place your first call
(see page 18).
10
I N S T A L L A T I O N S T E P S
S T E P
1. Put on headset.
2. Lift the phone's handset off the cradle
3. If you don't hear a dial tone, adjust the
1. Remove the Telephone Compatibility
2. Remove the flat, plastic screwdriver
3. Make sure the amplifier is in the default
4. Using the screwdriver, slide the
e n g l i s h
I N S T A L L A T I O N S T E P S
set telephone/amplifier
4
C o m p a t i b i l i t y S w i t c h
and place it on your desk.
Telephone/Amplifier Compatibility
Switch as indicated below:
Switch Access Door by placing two fin-
gers or thumbs on the raised bumps and
pushing down.
from the bottom of the amplifier by slid-
ing it through the braces holding it in
place.
settings, and your telephone handset is
off of its cradle.
Compatibility Switch until you hear a
clear dial tone. Experimenting with vari-
ous switch settings will not harm the
amplifier or your telephone.
e n g l i s h 11