Nice OXILR Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

3.4 - Deleting the receiver's memory (fully or partially)
In a one-way system, the memorisation or code deletion procedures involve the receiver alone. The one-way
transmitter transmits a single command, and it is the receiver that must recognise whether or not the transmitter
is authorised to enable the automation.
The two-way transmitter, after the sending of a command, becomes itself a "receiver" of information coming
from the associated receiver.
With the memorisation of two-way transmitters in the OXILR receiver, the identification code of the same re-
ceiver is automatically memorised by the transmitter. Warning! - if the two-way transmitter in the OXILR receiver
is deleted, to complete the operation it is necessary to also delete the transmitter's memory. To perform this
procedure, consult the transmitter's instruction manual.
PROCEDURE 5 - FULL or PARTIAL deletion of the receiver's memory
01. On the receiver: hold down key A and observe the status of
the green LED B: after 6 seconds it will light up then switch
off. After a few seconds it will start flashing; then immediately
choose the type of desired deletion:
> to delete ALL the transmitters: release key A exactly at the
3 flash
rd
> to delete ALL THE RECEIVER'S MEMORY: release key A
exactly at the 5
> to delete (in the receiver) the Series/Address of the
control unit, for the BusT4 network: release key A exactly at
the 7 flash
th
This function can be performed also using the O-Box / O-View programmers.
flash
th
English - 10