Remote Control - TomTom Remote Control Manual De Instrucciones

EN

Remote control

Important: This TomTom product is Bluetooth
Remote
control
enabled. Please note that in certain environments
such as hospitals or airplanes, you are required to
switch off Bluetooth, on all electronic devices.
Inserting the batteries
1. Hold the sides of the remote control and press the
2. Place the batteries in the remote control. Make
3. Replace the battery cover and press any button to
Note: If you do not use your remote control for 20
seconds, it goes into power saving mode.
If you do not use your remote control for one hour,
the remote control switches off completely.
Press any button to switch your remote control on.
latch on the back of the device.
The keypad lifts out from the back of the device,
as shown in the diagram. Take care not to drop
the keypad.
sure you put the batteries in the correct way
round, as shown on the remote control.
switch on your remote control.
Your remote control starts searching for your
TomTom GO.
4