Sliding Rack Kit Assembly; Remplacement De L'aMpoule D'éClairage - Hotpoint FK 61 X /HA S Manual De Instrucciones

For more thorough cleaning purposes, the oven door may
GB
be removed:
1. Open the oven door fully (see diagram).
2. Use a screwdriver to lift up and turn the small levers F
located on the two hinges (see diagram).
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.
Remplacement de l'ampoule d'éclairage
! Ne pas utiliser la lampe du four comme éclairage de la
pièce.
30
F
3. Grip the door on the two outer
sides and close it approximately
half way. Pull the door towards you,
lifting it out of its slot (see diagram).
To replace the door, reverse this
sequence.
Pour changer l'ampoule
d'éclairage du four:
1. Dévissez le couvercle en
verre du boîtier de la lampe.
2. Dévissez l'ampoule et
remplacez-la par une autre
de même type : puissance
25 W, culot E 14.
3. Remontez le couvercle à
sa place (voir figure).

Sliding rack kit assembly

A
Left
Right guide
guide rail
rail
B
C
D
! Do not place the sliding racks in position 5.
Side and rear catalytic liners*
These are panels coated with a special enamel, which is
able to absorb the fat released by food as it cooks.
This enamel is quite strong, so that the various accessories
(racks, dripping pans, etc.) can slide along them without
damaging them. White marks may appear on the surfaces;
these are not a cause for concern.
Nevertheless, the following should be avoided:
- scraping the enamel with sharp objects (a knife, for
example);
- using detergents or abrasive materials.
*
Only available in certain models.
To assemble the sliding
racks:
1. Remove the two frames,
lifting them away from the
spacers A (see figure).
2. Choose which shelf to use
with the sliding rack. Paying
attention to the direction in
which the sliding rack is to
be extracted, position joint
B and then joint C on the
frame.
3. Secure the two frames
with the guide rails using the
holes provided on the oven
walls (see diagram). The
holes for the left frame are
situated at the top, while the
holes for the right frame are
at the bottom.
4. Finally, fit the frames on
the spacers A.