Contents Of Package - Carrera RC Mario Kart 8 Mario Instrucciones De Montaje

D Never use the Carrera RC vehicle out-
doors during rain or snowfall. The car must
not be run through water, puddles and snow,
and must always be kept stored in a dry place.
E Never operate the vehicle near rivers,
ponds or lakes, to avoid the risk of the Carrera
RC car falling into the water. Avoid running on
courses which are laid exclusively with sand.
F Do not expose the Carrera RC vehicle to
direct sunlight. To avoid the electronics in the
car overheating, when temperatures are
above 35 ° C, regular short pauses in opera-
tion are essential.
G Never subject the Carrera car to repeated
changes of load – that means continuously
reversing it.
H
Always place the car on the floor by hand.
Never throw the car on the floor from a stand-
ing position.
I Avoid jumping from jumps or ramps higher
than 5 cm (0.16 ft.).
K Never use strong solvents for cleaning the
car.
L To avoid malfunctions to the control sys-
tem resulting in uncontrolled operation of the
Carrera RC vehicle, check that the controller
batteries and the rechargeable batteries in
the vehicle have sufficient charge.
M The Carrera RC vehicle must be inspected
before and after operation, each time it is used,
to ensure that it has not become disassembled.
Any screws or nuts that may have become
loosened during operation must be tightened.
ENGLISH
Instruction Manual

Contents of package

1 1 x Carrera RC Vehicle
1 x Controller
6 x 1.5 V Micro AAA batteries
(non-rechargeable)
Inserting the batteries in the vehicle
2 Using a screwdriver, remove the cover of
the battery compartment in the Carrera RC
car. Insert the Carrera RC batteries (not
recharge ables) in the vehicle. Ensure the po-
larity is correct. Replace the compartment
cover using a screwdriver.
Inserting the batteries in the
controller
3 Open the battery compartment with a
screwdriver and insert the batteries in the re-
mote control. Ensure the polarity is correct.
Replace the compartment cover using a
screwdriver.
Now you can drive the car
The Carrera RC car and the remote control
are bound as a factory setting.
4 1. Switch the car ON at the ON/OFF
switch. The LED on top of the car will flash
rhythmically.
5 2. Switch on the controller. The LED on
top of the controller will flash rhythmically.
After a few seconds, the LEDs on the car and
on the controller will light continuously, mean-
ing the bind has been made.
6 Adjusting the steering
If the Carrera RC vehicle is found to pull to-
wards the left or right while moving, use the
adjuster control shown in the illustration to
adjust the car's track precision.
12