Troubleshooting - Carson R/C ROCK CRAWLER X-CRAWLEE Manual De Instrucciones

Change the gear to High & Low
CAUTION:
1. If the switch cannot be pushed smoothly,
push it while turning the tire by hand.
2. The wheels will not turn if the gears
are not set to high or low position completely.
3. Change the switch of front and rear to High and/or Low
position, Front and rear must always have the same setting,
or the different setting will cause damage to the car.
Low High
BATTERY SAFETY GUIDELINE
1. Take care to fi t your batteries correctly, observing the plus and minus marks on the battery and transmitter.
2. Replace the whole set of batteries at one time, taking care not to mix old and new batteries or batteries of different types.
3. The supply terminals are not to be short-circuited.
Store unused batteries in their packaging and away from metal objects which may cause a short-circuit.
4. Remove dead batteries from transmitter and all batteries from transmitter you know you are not going to use for a long time.
Otherwise the batteries may leak and cause damage.
5. Never dispose of batteries in fi re as this may cause them to explode. Please put dead batteries in with the normal household
waste.
6. Never attempt to recharge ordinary batteries, either in a charger or by applying heat to them. There are special rechargeable
batteries which are marked as such.
7. Supervise children if they are replacing batteries themselves in order to ensure these guidelines are followed.
Trouble Shooting
Problem
Car doesn't move
Loss of control
Car doesn't run straight
Car is running too slowly
Short range
Cause
Transmitter or chassis power switch is not "ON".
Polarity or battery type is wrong.
Battery has run down.
High/Low gear switch are not properly engaged.
Batteries have run down.
Antenna is missing or not attached properly.
Same frequency R/C model is using nearby.
Steering trim is not adjusted correctly.
Front and rear wheel nuts are too loose
Batteries have run down.
Batteries have run down.
①PUSH
②SLIDE
Push and slide to change gear setting
Low High
Correction
Switch power on.
Check the battery polarity and type.
Change batteries to new one or charge them.
Set the front/rear switch so fully engaged.
Change batteries to new one or charge them.
Attach antenna correctly and extend transmitter
antenna to full length.
Run model in different area.
Adjust the trim correctly.
Tighten wheel nuts.
Change batteries to new one or charge them.
Change batteries to new one or charge them.
9