Metronic QU4Dbox Manual De Instrucciones página 81

This command works with non-removable battery. NOTE: The warranty does not
cover damage due to handling the battery compartment. Some functions may not
be controlled by the universal remote. Using the original remote.
1 - Set up by brand code*
1. Switch on the device (TV for example) for which you wish to use the remote
control.
2. Find the code number of your device brand in the code list (e.g. Lifetec 0050) from
the relevant device group (TV).
3. Press and hold the device button (e.g. TV) for three seconds.
4. Release the device button as soon as LED lights up, now it is in set up mode.
5. Enter the 4-digit device code (e.g. 0050 for Lifetec TV) within 10 seconds. If an
entry is not made within 10 seconds, the set- up mode is automatically terminated.
6. The LED turns off if the remote accepts the code. If the LED flashes two times,
that means the code may be wrong, and the remote control remains in set-up
mode, enter the correct code from the list again.
7. Check the function of the buttons on the remote control. If it does not function
correctly, try another 4-digit device code (e.g. 0057...) from the list under the same
brand. Repeat steps 3 to 6 until all the basic functions operate correctly.
8. Note: Exit the set-up mode by pressing the device button, or the set-up mode is
automatically terminated if no button is pressed for 10 seconds.
* Device code list available at: www.metronic.tv
2 - Set up by automatic search
If setting up by brand name and codes is not successful, or you can not find your brand
name in the code list, you can use the Automatic Search function to find the correct
code for your remote control.
1. Switch on the device that you like to control. If it is a DVD, insert a disc and press PLAY.
2. Point the remote control at your device. Press the device button (e.g. TV) for three
seconds, the LED turns on, keep pressing the device button for about two seconds
until the LED starts flashing, that means it is in Automatic Search now and you
can release the device button.
3. The "Volume+" signal is automatically transmitted from the remote control to
the device (code scan). As soon as the volume of the device (e.g. TV) changes,
immediately press the device key to stop the Automatic Search.
4. If the device you are searching for is a CD player, Tuner, TAPE, or AUX, a power
signal is automatically transmitted from the remote control to the device. As soon
as the device turns off, press the device key to stop the Search. You need to turn
on the device by pressing the Power button before you can check the functions of
the other buttons.
5. Check the functions of the other buttons on the remote control. If none of the
buttons function (i.e. the search cannot be stopped at the correct time) or the
READ CAREFULLY
technical support: soporte@metronic.com
EN
5