Pairing To The Ab Mypilot - Advanced Bionics Naida Cl Q70 Manual De Instrucciones

To attach an FM Receiver to the ComPilot:
1
With the ComPilot turned off, hold the
ComPilot in one hand. With the other hand,
align the three FM connector pins with the
Europort on the ComPilot. Take care to ensure
that the FM receiver pins match the size and
orientation of the holes on the ComPilot.
Failure to do so may cause damage to the FM
receiver and/or the ComPilot.
Adjust the program position on the processor or AB myPilot to the desired program for FM use.
3
Reduce volume settings.
4
Turn on the ComPilot.
5
Adjust the volume to the desired level for FM use.
6
To remove an FM receiver:
1
With the ComPilot turned off, hold the
ComPilot in one hand.
Readjust the program position and volume to their desired settings for non-FM use.
3
For further information regarding FM use, refer to the
32
Naída CI Sound Processor User Guide
2
Firmly press the FM receiver into
place on the ComPilot.
2
With the other hand, gently pull the FM
receiver straight out of the Europort.
Instructions for Use
included with the FM system.

Pairing to the AB myPilot

In order for the AB myPilot to control the Naída CI(s), it must be paired to the processor/s. The
AB myPilot may be un-paired and paired to multiple Naída CI processors. This allows one AB
myPilot to be used with all Naída CI recipients in a classroom. This may also be convenient for a
caregiver with several implanted children. They would only need one AB myPilot to have remote
control access to everyone.
The AB myPilot must be paired to your Naída CI within five minutes of the processor starting
up. This time period is referred to as the Pairing Window and it begins upon the attachment of
the PowerCel or Zn-Air Battery Pak or Power Adapter to the Naída CI.
After the five minute Pairing Window ends, pairing is no longer possible. If you need more time
to pair, you must remove and replace the Naída CI battery to begin the Pairing Window again.
Sound input to the processor is not affected during this period. If pairing is not desired, the user
can proceed with normal use of the Naída CI during this time.
To Begin Pairing the AB myPilot to the Naída CI:
Make sure a hearing care professional has enabled remote control functionality on the
1
Naída CI.
Have the Naída CI you want to pair within 11 inches (30 cm) of the AB myPilot remote control.
2
Attach the PowerCel, Zn-Air Battery Pak, or PowerCel to the Naída CI, commencing the
3
Pairing Window (five minute time out).
4
Upon turning on the AB myPilot will read the
following, 'The AB myPilot needs to be paired
with your hearing instruments.' Press the
center button on the remote control.
5
The main menu will be shown; from this
menu, click the downward arrow button
to highlight the Pairing option. Press the
center button again to select.
33
Naída CI Sound Processor User Guide