IV. Network Connection
4.1 Wi-Fi
In order to use Wi-Fi you must be within range of a WiFi router and have its network password in case it's
Password protected. Under Setting>Wireless & networks, tap "Wi-Fi". Ensure that both Wi-Fi and Network
Notification are enabled with green check marks. After a moment, your Wi-Fi networks list should
populate. If you need to rescan for available networks, tap "Wi-Fi", then will automatically scan. For
secured networks, you need to input the password or some other form of access agreement
acknowledgement via a browser.
We advise you to safeguard your wireless internet router according to the WPA protocol instead of the WEP
protocol. When using WEP, be aware that the tablet does not support all channels and the range is lower than
when using WPA.
4.1.1 Turn on Wi-Fi
Within the App Panel, tap "Settings" → then "Wireless & networks" → "Wi-Fi" → "ON" to turn on and scan.
Your tablet lists the networks it finds within range. Tap a network to connect. If necessary, enter Network
SSID, Security, and Wireless password, and tap "Connect". When your tablet is connected to the network,
the wireless indicator
appears in the status bar. Waves indicate signal strength
4.1.2 Turn off Wi-Fi
To turn off Wi-Fi, tap "OFF" under "Wi-Fi". Turn off Wi-Fi when you're not using it, to extend the life of
your battery between charges.
4.1.3 Data Usage
Mobile data: you may check the data by tap "ON"
Set Mobile data limit.
Data usage cycle: current usage cycle, change cycle
4.1.4 More: VPN, Portable hotspot, Mobile networks
Add VPN network
VPN type: PPTP
Portable Wi-Fi hotspot: Choose to active portable hotspot AndroidAP
Configure Wi-Fi hotspot: enter into Network SSID, Security, Password
Mobile Network Setting
Modem Power: Turn on/off modem power
Data enabled: Enable data access over Mobile network
Data roaming: connect to data services when roaming
Access Point Names
Use only 2G networks: Save battery
Network Operators: Select a network operator
8