Clatronic HSM-R 2757 Instrucciones De Servicio página 33

5....-05-HSM-R 2757
Battery operation
You can use your hair and beard cutting machine with the battery once this has
been charged up. The device is partly charged when it leaves the factory. Please
charge the device for a period of 12 hours before using it for the first time. To char-
ge up the device, insert the plug of the power pack into a 230 V/50 Hz socket and
then connect the cable with the connection socket (5) of the charging station (6) or
directly with the device. Move the function switch to the "O" position. The maximum
length of the subsequent charge cycles is approximately 8 hours. When fully char-
ged the device has a maximum operating time of 25 minutes. After this time it must
be switched off and allowed to cool down for 10 minutes. The charging LED lights
up during the charging procedure.
Useful tips regarding battery life
Battery life can be lengthened by paying attention to the following instructions:
• Wait until the battery is almost completely flat before recharging.
• Never leave the machine connected to the charger for more than 24 hours.
• Charge the machine only with room temperature between 0 and +40°C.
Beard trimming and cutting
Shift the selector (2) to the I position. Start with the longest cutting level and trim
your beard gradually to the desired length.
Note: Lock the desired cutting length (cutting length comb) into place with the func-
tion ring (7).
released:
locked:
thinning function: The further you turn the function ring in the direction of the
Hair cutting
Shift the selector (2) to the I position: Start with the longest cutting level and shor-
ten the hair gradually to the desired length.
Note: Lock the desired cutting length (cutting length comb) into place with the func-
tion ring (7).
Contour cutting and neck shaving
Remove the cutting length comb (3) and shift the selector (2) to the I position. Turn
the function ring (7) to the
ming of the beard contours even areas, which are difficult to reach, and a clean
shaving of the hairline in the neck area.
25.06.2003 10:39 Uhr
It is now possible to adjust the cutting length comb
Now you can cut your hair or beard with the length of the
cutting length comb that has been set
thinning symbol, the fewer hairs are thinned out.
position. The shearing head enables the precise trim-
Seite 33
GB
33